100% High Quality Gateway M-1600 Series Laptop CPU Cooling FanSpecification:Unit: 1 pcs
Type: Laptop CPU Fan
Compatible with Part Number: KSB0405HACondition: Original Brand New
Info: (3 wire) 3-pin Connector
Warranty: 3 months
Remark: Tested to be 100% working properly.
Product Introduction:Gateway M-1600 Fan
are made from highest quality parts, the Gateway laptop fan are tailored
made according to the original size, whether the appearance, size and
quality are the same as with the original. Every Gateway M-1600 Fan
Cooling Fan should be under strict quality control before leaving the
factory, and has passed the authentication of CE, UL, EMC, CQC, ROHS,
etc.Fit Laptop Models:
Gateway M-1600 Series Laptop,
Gateway M-1618 Series Laptop,
Gateway M-1624 Series Laptop,
Gateway M-1626 Series Laptop
GATEWAY Laptop CPU Fan 100% Warranty:
*
100% Q.C. of
Gateway M-1600 Series Laptop CPU Cooling Fan .* Uses the highest quality parts.
*
100% Q.C. of EVERY product. Extended run time.
* 30 Days Money Back.
* Excellent Service.
*
100% compatible with original parts.
How to Replace a Gateway M-1600 Fan?
1.
Follow your laptop owner's manual and assembly guide carefully as you
disassemble the laptop. Touch something metal periodically to remove
static charge, and work on a large table with a bright light source.
2.
Turn off the laptop and unplug it. Remove the main battery, CD/DVD
drive and the hard drive. The hard drive is usually located in a slot on
one side of the laptop. Remove the screw that holds the cover in place,
then pull out the hard drive sled.
3. Turn the laptop over and
remove the screws on the bottom that hold the keyboard in place. Flip
the laptop over, open it, then lift the keyboard up and out. Unplug the
flexible ribbon cable that connects the keyboard to the motherboard.
4.
Remove the screws that hold the laptop keyboard bezel and palm rest in
place. Carefully pry loose any plastic snaps on the sides, then lift the
bezel and palm rest up and out.
5. Unplug the Gateway M-1600 Fan
Cooling Fan. Remove the screws that hold the heat sink and fan in place,
then remove the entire unit from the laptop. Remove any thermal
compound residue from the bottom of the heat sink and the CPU.
6.
Apply a thin layer of thermal compound on the CPU, then replace the
heat sink and fan. Replace the screws, plug the Gateway M-1600 Fan back
in, then reassemble the laptop.
7. Plug the laptop in and turn it
on. After you use it for a few minutes, you should hear the new fan
running and feel warm air blowing from the vent on the side of the
laptop. A Gateway M-1600 Fan does not run continuously, so don't be concerned if the Gateway M-1600 Fan shuts off periodically.
This product was added to our catalog on Sunday 05 December, 2010.
