100% High
Quality HP Pavilion DV6Z-3000 Series Laptop
Keyboard
Specification:Layout:
US
Letter: English
Regulatory Approval: CE, UL
Condition: Original/new! Warranty: 12 months
Colour: Black
Remark: Ribbon cable included
Availability: in stock
Product Introduction:Brand New Keyboard with ribbon cable, 100% manufacturer compatible, Each
HP Pavilion DV6Z-3000 Series Keyboard is tested before shipping and are 100% working.
HP Pavilion DV6Z-3000 Series Keyboard Fits Parts NO. * HP 593296-001 Keyboard * HP 594597-001 Keyboard * HP 606743-001 Keyboard * HP 9Z.N4CUQ.001 Keyboard * HP 9Z.N4CUQ.003 Keyboard
* HP AELX6U00210 Keyboard
* HP AELX6U00410 Keyboard
* HP AELX8U00310 Keyboard * HP LX6 Keyboard
* HP NSK-HR0UQ Keyboard
* HP V112846AS1 Keyboard Fits Laptop Models. * HP Pavilion DV6Z-3000 Series Keyboard
HP Pavilion DV6Z-3000 Series Keyboard Repair and ReplacementAre you considering
laptop keyboard
repair? You might think twice if you happen to be the lucky owner of a
laptop, because replacing the keyboard rather than repairing it could be
a lot less expensive. Laptop keyboard replacement on this particular
model is very easy and takes just a few minutes. Here is a quick
HP Pavilion DV6Z-3000 Series Keyboard repair tutorial with step-by-step instructions.
Once you have purchased the
new keyboard,
all you need to replace the old with the new is a screwdriver and
something plastic, flat and thin like a credit card or guitar pick.
Step one: Remove the two screws from the bottom of the computer that are holding down the
HP Pavilion DV6Z-3000 Series Keyboard bezel. The bezel is the bar that sits right above all the function keys.
Step two:
Turn the computer over, open the cover and insert the credit card or
guitar pick between the bezel and the laptop screen. The bezel has pegs
that sit in holes, you need to slowly pry up the bezel. It will make a
bit of a popping noise as it is removed.
Step three: Now hold on to the
laptop keyboard
from the end closest to the screen and gently pull it away from the
touch-pad end and flip it over. You will see the ribbon attached to the
underside of the
HP Pavilion DV6Z-3000 Series Keyboard.
There is a little plastic connector holding the ribbon to the computer.
To unlock it, carefully pull up on the two tabs; one located on each
corner of the connector. Be very gentle when you do this as this is the
one part that gets broken the most often when changing a keyboard. The
ribbon cable will now be released.
Step four: Carefully pull the ribbon out of the connector and remove it along with the entire
HP laptop keyboard.Final step: To insert the new
HP Pavilion DV6Z-3000 Series Keyboard,
place the board face down so you have easy access to the ribbon. Make
sure the keyboard is lined up so when you flip it back over the keys are
in the correct position. Keep the ribbon straight at all times;
twisting it could damage it. Place the ribbon in the connector; it only
goes in one way. Once in place, push down on the connector tabs to lock
it. Now flip the keyboard over and slide it down toward the touch pad
and take the bezel and line the pegs up with the holes and push it in
place. Then turn the computer over and replace the two screws you
removed from the bottom. You can now power on your computer and see if
the
HP Pavilion DV6Z-3000 Series Keyboard works. If it is not working, more than likely the ribbon was not inserted properly.
This product was added to our catalog on Saturday 07 April, 2012.