IBM Lenovo W500 Laptop CPU Fan MCF-224PAM05 45N5491 45N5490

100% High Quality IBM Lenovo W500 Laptop CPU Cooling Fan 

Specification:
Unit: 1 pcs
Type: Laptop CPU Fan
FRU P/N：IBM Lenovo MCF-224PAM05 MCF-217PAM05 45N5491 45N5490 42W2461 42W2460
Condition: Original and Brand New
Warranty: 3 Months
Remark: Tested to be 100% working properly.

Product Introduction:

IBM ThinkPad W500 Fan are made from highest quality parts, the IBM laptop fan are tailored made according to the original size, whether the appearance, size and quality are the same as with the original. Every IBM ThinkPad W500 Fan Cooling Fan should be under strict quality control before leaving the factory, and has passed the authentication of CE, UL, EMC, CQC,ROHS, etc.

Fit Laptop Models:

IBM Lenovo T500 Laptop,
IBM Lenovo W500 Laptop

IBM Laptop CPU Fan 100% Warranty:

* 100% Q.C. of IBM Lenovo W500 Laptop CPU Cooling Fan.
* Uses the highest quality parts.
* 100% Q.C. of EVERY product. Extended run time.
* 30 Days Money Back.
* Excellent Service.
* 100% compatible with original parts.

How to Replace a IBM ThinkPad W500 Fan?

1. Follow your laptop owner's manual and assembly guide carefully as you disassemble the laptop. Touch something metal periodically to remove static charge, and work on a large table with a bright light source.

2. Turn off the laptop and unplug it. Remove the main battery, CD/DVD drive and the hard drive. The hard drive is usually located in a slot on one side of the laptop. Remove the screw that holds the cover in place, then pull out the hard drive sled.

3. Turn the laptop over and remove the screws on the bottom that hold the keyboard in place. Flip the laptop over, open it, then lift the keyboard up and out. Unplug the flexible ribbon cable that connects the keyboard to the motherboard.

4. Remove the screws that hold the keyboard bezel and palm rest in place. Carefully pry loose any plastic snaps on the sides, then lift the bezel and palm rest up and out.

5. Unplug the IBM ThinkPad W500 Fan Cooling Fan. Remove the screws that hold the heat sink and fan in place, then remove the entire unit from the laptop. Remove any thermal compound residue from the bottom of the heat sink and the CPU.

6. Apply a thin layer of thermal compound on the CPU, then replace the heat sink and fan. Replace the screws, plug the IBM ThinkPad W500 Fan back in, then reassemble the laptop.

7. Plug the laptop in and turn it on. After you use it for a few minutes, you should hear the new fan running and feel warm air blowing from the vent on the side of the laptop. A IBM ThinkPad W500 Fan does not run continuously, so don't be concerned if the IBM ThinkPad W500 Fan shuts off periodically.